Incorrect software dipswitch settings. FM1 Paper exit fan failed. Remove the fusing unit cover by loosening two screws. Solution Here is a list of some of the legacy black and white models. To lower the transfer current value, perform the following: Konica recommends feeding transparencies through the bypass tray to reduce the occurrence of misfeeding. 
| Uploader: | Malajind |
| Date Added: | 14 May 2016 |
| File Size: | 10.91 Mb |
| Operating Systems: | Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X |
| Downloads: | 89346 |
| Price: | Free* [*Free Regsitration Required] |
– ALL ACTIVE SOLUTIONS June |
minoltw Worn components or a build up of foreign material in the main drive or drum drive units. Can the copier be set to continuously print when the finisher is installed?
Failed PS31 on the cleaning unit. The punch unit main motor never energizes. When the sensor is blocked by paper [H] will be displayed on the touchscreen. Touch the left up-arrow twelve 12 times.
Konica Minolta 7085/ip602 Driver
Press and hold the P Key until [Enter 4-digit password to change Mode] is displayed. The lock shaft holder, which has a one-way bearing, has failed causing loss of drive to the feed rollers. I wil keep coming back for sure. If 25 mode is set to a 0, The following options are minolha To check the original conveyance sensor PS 7058/ip-602 47 mode, input code 60, PP.
Actuate PS and check for a change of state at the control panel. These special papers must only be fed from the multi-sheet bypass tray. Access the 25 mode power the machine OFF while holding down on the 2 and 5 keys.
Access the memory setting mode menu by pressing the 2 and 5 keys while powering the machine ON. The default is dpi. Display of the additional print list options has not been enabled within the 25 mode. Size Detection was not set to inch standard.
If a request is received without an established problem ticket number the request will be denied. To enable automatic centering, perform the following: Then, to enable HDD scanning, perform the following: New image processing boards are not normally pre-flashed with firmware. The allowable sizes for booklet mode are 8.
Normal output should be 36VDC. First, ensure that the hard drive is installed. Tabs cannot be plastic. Konica Minolta recommends that all service be performed by an authorized service representative.
If the part is cracked and developer is spilling out 70085/ip-602 the developing unit refer toattachedBulletin Number for corrective measures. For easy identification, the color of the new gears are black as opposed to the current white gears. June 51 To change the setting of in the 25 mode, perform the following: In the list of firmware, click on the required link to download.
Select the desired software dipswitch number in this case, ’22’ by pressing either the up or down arrow indication at the left. A damaged ADU driver board.
Solution Using the 25 mode, softswitch 3, bit 1 must be changed back to 0 off. The file will print immediately. Have a copy of a B for crediting the replacement developing unit. One or more of the exit guide plates has a notch or burr, causing the corner of the paper to fold dog ear or jam.
Clear Drivers Shop 